2014 Ford Fusion Engine Problems

Coolant is leaking into the head gasket of the 2014 Ford Fusion Hybrid similar to the other 2014 Ford Fusion cars (they have a recall on them for this issue). Upon calling the nearest Ford dealership, I was told that the recall did not apply to my vehicle, even though the same recall has been made for other 2014 Ford Fusions (just not the hybrid specifically). The safety of the driver and passengers in the car is at risk due to the coolant fluid mixing into the engine oil, eventually causing a blown head gasket and potentially engine failure. This problem was identified within minutes of getting a routine oil change, as coolant was found in the cap of the head gasket. The vehicle has not been inspected by the manufacturer, police, or insurance representatives. There were no warning signs. The car notified me when I needed to change my oil, but otherwise, no dash lights came on and no notifications were sent to the dash.

On cold startup, a significant amount of white exhaust is sometimes observed coming out of the tailpipes. The exhaust has a sweet aroma and after checking the coolant levels, it appears that the coolant levels have dropped and the exhaust smoke is being caused by a coolant intrusion into the engine block. No warning lights have been observed and it only happens about half of the time.

The contact owns a 2014 Ford Fusion. The contact stated that while his son was driving approximately 70 MPH, the check engine warning illuminated. The contact stated that the vehicle went into LIMP Mode, and his son was able to coast to the side of the highway. The contact drove out to his son's location and was able to clear the codes using a handheld scanner and the vehicle was able to be driven back to the residence. The contact stated that the failure was intermittent, and the vehicle was showing other symptoms. The contact stated that the vehicle was idling rough after a cold start and occasionally was blowing white smoke from the exhaust pipe. The contact stated that 2 years prior the vehicle exhibited the same symptoms, and the vehicle was taken to a dealer who diagnosed that there was coolant intrusion into the engine block, and the engine was replaced. The contact stated that the vehicle was under warranty at the time of the failure. The contact had taken the vehicle to an independent mechanic who diagnosed the vehicle and confirmed that there was coolant intrusion into the engine, and that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure and referred the contact to the NHTSA Hotline. The failure mileage was 86,825.

The contact owns a 2014 Ford Fusion. The contact stated that while starting the vehicle, the vehicle idled and then stalled. There was no warning light illuminated. The contact used a code reader to diagnose the vehicle. The contact filled the coolant reservoir and noticed that the coolant was leaking out. There was coolant intrusion into the cylinder, causing engine failure. The vehicle was towed to the dealer, and confirmed that there was coolant intrusion into the block head. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact related the failure to Technical Service Bulletin: 23-2223. The manufacturer was notified of the failure and the manufacturer referred the contact to the NHTSA Hotline to report the failure. The approximate failure mileage was 154,135.

The contact owns a 2014 Ford Fusion. The contact stated while driving 10 MPH, the vehicle was shaking with a rattling sound coming from the engine compartment. A code was displayed on the instrument panel; however, the contact was unsure what the code referenced. The contact stated that the vehicle was not safe to drive. The contact stated that an independent mechanic inspected the vehicle and diagnosed that there was a coolant leak, causing the coolant and oil to mix that caused engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The mechanic informed the contact of NHTSA Campaign Number: 17V209000 (Engine and Engine Cooling); which was related to the failure experienced. The manufacturer was informed of the failure and confirmed that the VIN was not included in NHTSA Campaign Number: 17V209000 (Engine and Engine Cooling) and opened a case. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 188,000.

I was having issues with this vehicle sputtering a bit and the antifreeze was seeming to be disappearing. There were no visible leaks. I took it to the shop to have it looked at. The engine light was on and there was a code for a cylinder 3 misfire. Th mechanic diagnosed the vehicle and, upon removing the spark plugs, noticed they were fouled with what he said was antifreeze in the cylinder (because of the white substance on the electrode end). I saw where there is a recall for the particular engine block that is in this vehicle from 2014 to 2020. When I notified Ford and the NHTSA I was told that my VIN number was not included in the recall. I am confused because I would think that the recall would be for vehicles with this particular block not specific VIN numbers. Please help! I just got this car hoping for a reliable vehicle. I am a grad student and I do not have the funds for such a big repair.

Experiencing repeated coolant leaks. Heating/coolant was repaired last winter. Failed again this winter. Car keeps needing additional coolant added. Will be taking it in on Monday to find out which parts failed this time.

The contact owns a 2014 Ford Fusion. The contact stated that while driving at various speeds, the vehicle lost automotive power and stalled. The vehicle was towed to the local mechanic who diagnosed that the engine had failed due to coolant intrusion into the cylinders. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in NHTSA Campaign Number: 17V209000 (ENGINE AND ENGINE COOLING). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 112,000.

I bought the 2014 Fusion in 2019 used. It had roughly 60 some thousand miles. I had to replace the motor at 94 thousand miles. Now at 131 thousand miles, I am faced with the same issue and need to replace the motor again after only 37 thousand miles. From what the dealer said (Copper Country Ford in Houghton Michigan) both issues have been coolant leaking into the cylinders and killing the motor. The first motor was around $4500.00 and now it is roughly the same $4500.00. So $9000.00 in 4 years!!!!! I called Fo Mo Co and they will do nothing to help. They say there is no recall and or order from NHTSA about this issue. Nor do they have any other programs to help resolve this issue or help pay for the repair. First Motor Replaced August 2020 at 94,000 Second Motor Died December 2024 at 131,000

The contact owns a 2014 Ford Fusion. The contact stated that while parked, it was discovered that the vehicle was slowly losing coolant. The failure became a reoccurring failure. The vehicle was taken to a local dealer however, a diagnostic test was pending. The vehicle was not repaired. The manufacturer was notified of the failure and referred to the NHTSA Hotline for assistance. The contact referenced an unknown manufacturer’s recall that was related to the failure; however, the manufacturer confirmed that the VIN was not associated. The approximate failure mileage was 47,000.

When accelerating from a stopped position, the throttle is staying stuck wide open. Without my foot on the accelerator, the engine still accelerates wide open. Stepping on the brake, doesn't do anything or make it stop. It has now happened 3 times in the last 2 weeks. I was not taking off at a fast speed. I was accelerating at a normal rate.

The contact owns a 2014 Ford Fusion. The contact stated that while adding coolant, the coolant was leaking out. The contact stated that while driving at an undisclosed speed, the vehicle failed to accelerate properly. The vehicle was turned off and restarted and there was smoke detected. The contact opened the hood and noticed that the coolant level was low. The check engine warning light was illuminated. The contact stated that the failure was related to NHTSA Campaign Number: 17V209000 (Engine and Engine Cooling). The vehicle was towed to the local dealer but was not diagnosed or repaired. The manufacturer was contacted and opened a case. The failure mileage was approximately 60,000.

The contact owns a 2014 Ford Fusion. The contact stated while driving at an undisclosed speed, an unknown warning light illuminated, and the contact noticed a ticking sound coming from the vehicle. The contact stated that the check engine warning light later became illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with engine failure. The contact was advised to take the vehicle to the dealer for assistance. The vehicle was towed to the dealer where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was repaired. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 32,000.

Complaints 11617112 and 11617127 Thank you for your patience with me!

On [XXX] ford premier out of waveland evaluated my car after I had to have it towed in due to overheating. The high temperature warning notification was lock and wouldn't change to normal after it cooled. I was not fully aware of my car overheating due to no warning other the the temperature overheat warning. A couple of days prior without driving it for 10hrs I noticed a moist to the exhaust pipe. When it broke down the engine had a misfire, a shake, and had not power to the engine to accelerate. There was 3 different puddles of fluids underneath the car. When I had spoke to the service department on this breakdown I made them aware of everything with one of the Mechanics witnessing the shake within the engine. There was a confusion on my part due to the sticker showing a 1.5l and my Insurance showing through carfax a 2.5l with also Descripting a 1.5l that showed for my car to be compatible to a 2.0l, 1.6l Installation of coolant system, that of which lead me to request recalls through Vin# on [XXX] through Verified and it was shown to be compatible for recall. Premier Ford service department Assured me that nothing was wrong with the coolant system that the power train control module reprogramming took care of the breakdown. He assured me when I picked up my car That nothing was wrong with my car. Except for me needing to go, change the brakes so that he could change the brake hoses that are part of the recall associated with the brakes. This was on [XXX]. On [XXX] I broke down again with the same issue with this time before the breakdown there was a stall when I started my car And when they had my car on [XXX] I asked them the check the Fuel Injections and he stated there was nothing wrong with the fuel injections. My car has shown every sign that shows through the coolant system of a fire hazard. I am requesting that the Department to assign the safety recall 17s09 to my vin# [XXX] . INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

This is a attachment to my last Inquiry.

My 2014 ford fusion titanium 2.0 ecoboost engine has Coolant leaks causing engine overheating, missfire on cylender 4, car keeps shuddering and stalling while driving. Contacted ford about this issiue they refused to fix it even though there is a mass recall on the same Caras mie for the same issiues

Vehicle showing signs of coolant leak with no visible of signs of coolant on ground. Check engine light came on and running rough on startup and high speeds. White smoke and sputtering under load. Took to local mechanic and had signs of coolant in #3 cylinder. Replaced all spark plugs and ignition coils along with thermostat and pressure tested. Vehicle still throwing codes and having heavy misfires in #3 cylinder with coolant loss. Stated will need a new long block. Vin number not covered by recall. But Def needs to be.

The contact's girlfriend owns a 2014 Ford Fusion. The contact stated that while his girlfriend was driving at various speeds, the check engine warning light illuminated. Additionally, the driver noticed that there was coolant leaking onto her foot while depressing the accelerator pedal. The contact stated that coolant was leaking onto the accelerator pedal and floorboard. The local dealer and a secondary dealer, Prosper Ford (2200 W University Dr, Prosper, TX 75078 – (214)736-7779), were notified of the failure and informed the contact that the VIN was not included in NHTSA Campaign Number: 17V209000 (Engine and Engine Cooling). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 200,000.

Car stalls then dies out well starting but engine is still on.