2008 Ford Ranger Body & Structure Problems

The rear frame is rotted I am a retired ASA certified in 5 categories Mechanic and I have my ranger apart now but I need new rear frame where the spring hangers rotted out and the bracket that runs the top of the gas tank is rotted out that holds the 2 frame rails is rotted out. THESE PIECES CANNOT BE WELDED. Needs a new frame.

FRAME HAS COMPLETELY RUSTED OUT AND IS VERY DANGEROUS TO DRIVE.

REAR END OF TRUCK IS ROTTING AWAY SPARE TIRE HOLDER BROKE WHILE DRIVING SPARE WAS HANGING DOWN HAD TO BE REMOVED LUCKILY IT STAYED ATTACHED TO THE TRUCK WITH THE CABLE AND DIDN'T HIT ANY VEHICLE'S THE BED IS EXTREMELY RUSTED IF I GET IN THE BACK OF THE BED IT CRACKS AND FEELS LIKE YOUR GOING TO FALL THROUGH BED IS BECOMING LOOSE AND LEANING TO ONE SIDE. ITS A 12 YEAR OLD VEHICLE SO I EXPECT SOME PROBLEMS BUT NOT THIS EXTENSIVE I FEEL LIKE ITS UNSAFE TO DRIVE WITHOUT A NEW BED ON IT

TOOK TRUCK IN FOR SMALL REPAIR ON POWER STEERING HOSE. MECHANIC TOLD ME THE UNDERSIDE IS SO RUSTED IT ISN'T EVEN SAFE TO DRIVE HOME. RECOMMENDS JUNKING VEHICLE.

FRAME RUSTING ON THE BED. IT IS LOOSE AND WOBBLY AND MAY COME OFF. VEHICLE ONLY HAS 55,000 MILES ON IT. NOTICED WHILE DRIVING DOWN THE HIGHWAY AND CHECKING OVER MY SHOULDER TO PASS. SAW THE BED OF THE TRUCK MOVING ABOUT.

2008 FORD RANGER. CONSUMER WRITES IN REGARD TO RUST OVER FRAME OF VEHICLE WHICH ATTRIBUTED TO OUR PROBLEMS. *AS *JS

TL* THE CONTACT OWNS A 2000 FORD RANGER. THE CONTACT STATED THAT THE FRAME OF THE VEHICLE WAS CORRODED. THE VEHICLE WAS NOT TAKEN TO THE DEALER AND THE MANUFACTURER WAS NOT CONTACTED. THE VEHICLE WAS NOT REPAIRED. THE FAILURE AND THE CURRENT MILEAGES WERE 78,000.

FIRST, WITH THE NON-TILTING STEERING WHEEL LOCATED WHERE IT IS, WITH A TALLER PERSON IT IS DIFFICULT-TO- IMPOSSIBLE TO LIFT THE FOOT OFF OF THE GAS AND TRANSFER IT TO THE BRAKE PEDAL AS THE DRIVER'S KNEES ENDS UP IMPACTING THE BOTTOM OF THE STEERING WHEEL. THIS MAKES IT NECESSARY TO JUST DO A SORT OF HEEL-ON-THE-FLOOR-FOOT-TILT-OR-SLIDE TO GO FROM THE GAS TO THE BRAKE WITHOUT STEERING WHEEL/KNEE INTERFERENCE. THIS IS NOT A PROBLEM IN THE FORD'S WE HAVE WHICH HAVE TILT STEERING WHEELS SECOND, A VISUAL CHECK SHOWS THAT THE BRAKE AND GAS PEDALS ARE CLOSE TOGETHER AT NEARLY THE SAME HEIGHT. FROM A 'STEP OVER' POINT OF VIEW THIS SHOULD BE A GOOD THING, BUT IT RESULTS IN LITTLE 'FEEL' FOR WHERE YOUR FOOT IS ACTUALLY PLACED WHEN ONE GOES TO STOP THE VEHICLE BY USING THE HEEL-TO-THE-FLOOR-FOOT-TILT-OR-SLIDE METHOD NECESSITATED BY THE LOW STEERING WHEEL POSITION. THIS CAN AND DOES RESULT IN PRESSING BOTH PEDALS SIMULTANEOUSLY. IN ONE DAY OF DRIVING I MANAGED TO DO THE 'BOTH PEDAL PRESS' THREE TIMES, ANY ONE OF WHICH COULD HAVE RESULTED IN AN ACCELERATION INTO ANOTHER VEHICLE OBJECT. *TR