2016 Ram 1500 Engine Problems

Recall for intake manifold for our ecodiesel 2016 Ram and you do not show a recall for our specific truck. Which, GM service has verified we need to replace the intake manifold. Hesitation, drag, engine light, etc...

The 3.0 eco diesel has a known defect involving the oil pickup tube clogging up with soot and diesel particles which then causes catastrophic damage to the engine and they blow up due to engine bearing failure which could lead to a safety issue while operating the vehicle on the roadways there are numerous videos online regarding this issue and it needs address and mopar needs to correct this and recall all the trucks and replace the engines and redesign the oil pickup tube to prevent the oil pickup tube from clogging up it’s unfair to the owners of the trucks and so many of the trucks are being scrapped due to the engine failure issues new engines cost $11-$18,000 to replace

The common hemi tech where lifter bearing seize up and eats the come. So common you can buy top end rebuild kits just for tha reason.

The contact owns a 2016 Ram 1500. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly sputtered and then lost motive power, with several unknown warning lights illuminated. The vehicle was towed to an independent mechanic, but was not diagnosed. The mechanic stated that an error code was present, but had not provided the code to the contact. The contact was referred to the dealer for assistance. The vehicle was not repaired at that time. The vehicle was then towed to the dealer, where it was diagnosed, and determined that the crankshaft position sensor tone wheel had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact that the VIN was not included in NHTSA Campaign Number: 20V475000 (Engine and Engine Cooling). The approximate failure mileage was 216,000.

The contact owns a 2016 Ram 1500. The vehicle was repaired under NHTSA Campaign Number: 22V406000 (FUEL SYSTEM, DIESEL). The contact stated that while driving at an undisclosed speed after the vehicle was picked up from the dealer, the engine warning light illuminated. While driving a short distance later, two unknown warning lights illuminated, and the message “Exhaust Filter 100% FULL - Safely Drive at Highway Speeds” was displayed. After exiting the freeway, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The vehicle was taken to the dealer, where it was diagnosed and determined that the left engine manifold, catalytic converter, and the air intake had failed. The vehicle remained at the dealer unrepaired. The contact related the failure to NHTSA Campaign Number: 22V406000 (FUEL SYSTEM, DIESEL). The contact stated that since the remedy was not available when the recall was issued, the delay created additional damages to the vehicle. The manufacturer was made aware of the failure and informed the contact that the recall repairs were already completed. No assistance was provided. However, a claim was filed with the manufacturer. The failure mileage was approximately 204,000.

2016 RAM Ecodiesel in shop with crankshaft position sensor error. Vehicle available for inspection at Sarasota RAM. Vehicle shut down on highway. Restarted but only would operate in limp mode which enabled me to drive to dealer. Warning lights indicated crankshaft position sensor issue. I had W58 recall performed but not selected for W68 fix. I spoke to Phil (844-378-0573 Ext: 4060587) at RAM customer care, who stated "Our primary focus is your satisfaction" (customer care case #[XXX]). This problem is very evident by the many 1500 drivers complaints. Action to reimburse me for the repairs is required. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The engine on this vehicle has failed, it has 51,000 miles on it and involved in a class action lawsuit that closed in 2022. This truck was bought in 2023 with dealership not disclosing all of the failures in the vehicle. It is at a local shop requiring $16,000 worth of engine repair and we are demanding from Dodge to have help with repairs. We had and have a record of regular maintenance completed on this vehicle and is in immaculate condition.

The contact owns a 2016 Ram 1500. The contact stated that while driving 60 MPH, the vehicle inadvertently lost motive power. The contact was able to pull over to the shoulder of the roadway, where the failure persisted. The vehicle returned to normal functionality, but the failure became a regular occurrence. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the crankshaft position sensor tone wheel. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 23V411000 (Engine and Engine Cooling), but the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was 56,000.

In September 2016 I purchased a new RAM 1500 echo diesel. On [XXX], I driving along [XXX] in southern Indiana. I lost all power, smoke started coming thru the dash vents, I get off the road, shut the engine off, raise the hood, a little smoke was coming from under the engine cover, popped it off didn't really see anything burning, I opened the air filter lid and and there was smoke, I blew the smoke out of it and replaced it. I got back in the truck, it started but still had no power. It idled fine. I called and towed it to John Jones Auto Group in Corydon, IN, this was all on [XXX]. I was contacted 30 June 2025 that the Intake Manifold had failed and needed to be replaced. I gave them the go ahead to replace it. They called me and told me it was ready. the following week and told the Intake Manifold failed and needed to be replaced. I gave them go ahead to repair it. They told me the Intake manifold replaced and ready for pick-up. When I went to pick it up, on 22 July 2025. The Tech showed me the intake manifold; it looked like it had melted. He also said the water pump was leaking and should be replaced. I paid for the repair for the intake manifold, left the truck and drove my car home, intending to have someone run me there and I would drive the RAM home. After thinking about a day or 2 I called John Johns and told them to go ahead and replace the water pump and took the key back to them. I didn't want it to fail when I was least expecting it. AT this point I've spent $4,750.20. They called I went and picked the truck up on 23 Jul 25, drove it home (20 miles) on [XXX] I just pulled out of my driveway, check the rearview mirror and saw all this white smoke coming out of the exhaust. I pulled over smelled the fumes it wasn’t diesel fumes, but it smell sweet. I turned around took the RAM back home and drove my car to work. I call John Jones Auto. After the advisor talked to the mechanic he told me it was normal and it was okay to drive INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I have found countless problems with broken bolts on the exhaust manifold on the web. Technical service bulletins have been written involving the problem. It is a known problem and continues.

The contact owns a 2016 Ram 1500. The contact stated that upon starting the vehicle, the check engine warning light illuminated. The vehicle was taken to a local dealer where the vehicle was diagnosed, and the contact was advised that the air filter was faulty and needed to be replaced. The vehicle was repaired; however, months later the failure reoccurred. The contact stated that when the vehicle was started, there was a misfire coming from the engine. The vehicle was taken back to the same dealer where the vehicle was diagnosed and the contact was advised that the EGR cooler assembly, intake manifold, NOX sensor, and the exhaust particulate sensor were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage 107,000.

Due to low oil pressure vehicle engine seized while driving on freeway. After having it towed to local dealer, I was quoted $19,000 to replace the engine because it could not be repaired.

The contact owns a 2016 Ram 1500. The contact stated that while her husband was driving 30 MPH, the vehicle lost motive power. There was smoke and oil coming from the engine. The driver was able to pull off the roadway. The check engine warning light illuminated after the failure. The vehicle was towed to the residence. The contact received notification of NHTSA Campaign Number 22V406000 (Fuel System, Diesel); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 140,000. Parts distribution disconnect.

I own a 2016 Ram 1500 EcoDiesel (VIN: [XXX] ). This vehicle is covered under the EcoDiesel Approved Emissions Modification (AEM) Settlement extended warranty. Since the update in January 2025, the truck has suffered repeated EGR system failures and related warranty failures. The EcoDiesel lawsuit itself was based on EGR cooler defects that could leak coolant and cause fires. My truck has experienced the same failure pattern, with coolant leaks, overheating, and unsafe breakdowns. On [XXX], the vehicle shut off in the middle of the road while I was driving, creating a serious hazard. The cause was traced to a covered emissions component. This was not an isolated incident. The vehicle has been in dealerships for over 60 cumulative days since January 2025, mostly for repeated EGR codes and fuel system issues, but the root problem has never been properly repaired. On [XXX], the low-pressure fuel pump failed after it had already been replaced. The premature failure left me stranded and required a $500 tow. This failure also presented a risk of sudden power loss in traffic. Despite repeated visits to authorized dealers, repairs are incomplete or improperly billed, including installation of non-OEM parts that failed again. The repeated stalling, coolant leaks, overheating, and sudden no-start conditions show that this truck remains unsafe to operate on public roads. I am reporting this as a safety defect because the emissions system failures and improper repairs have caused the vehicle to shut off while driving and continue to present a risk of fire, engine damage, and sudden loss of power. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

My truck was in the dealer for a 66A recall on the crankshaft positioning sensor. The recall states the magnetic material attached to the tone wheel if lost the engine loses its ability to synchronize injector pulse and cam timing. The fix was a PCM reprogram to maintain engine operation if signal is lost. There is a prior recall W68 which address the tone ring for replacement on 2014-2016 model code DS W68 states loss of crankshaft position. the fix under this recall is to replace tone wheel and crank shaft positioning sensor. Because they could lose magnetic material on the tone wheel causing loss of signal from the crankshaft positioning sensor to the PCM. my truck loss power and showed throttle positioning sensor fault and engine light came on . i brought my vehicle into the dealer they diagnosed code po336-00 crankshaft positioning sensor performance. on further inspection found tone wheel has chunk of material missing causing code. they replaced tone wheel as instructed by W68 recall so why is my truck not covered under this recall for the exact same problem.

The contact owns a 2016 RAM 1500. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate. The contact stated that the vehicle went into limp mode. In addition, the contact stated that several unknown warning lights were illuminated. The contact stated that a nearby driver honked the horn, and the contact was informed that fire was coming from underneath the front of the vehicle. The contact parked the vehicle and turned the vehicle off. The contact called the fire department. The contact had a fire extinguisher in the vehicle. The contact extinguished the fire prior to the fire department's arrival. The vehicle was towed to the dealer, where it was diagnosed with a failed engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact was informed that the dealer does not repair the engine; the dealer only replaces the engine. In addition, the contact stated that the failure had previously occurred in November 2024. The contact stated that the failure descriptions. The contact stated that the failure was diagnosed as a failed intake manifold and oil in the turbocharger. The intake manifold, the EGR valve, and the turbocharger were replaced. The vehicle was repaired. The failure reoccurred. The manufacturer was not made aware of the failure. The failure mileage was approximately 123,000.

The contact owns a 2016 Ram 1500. The contact stated that while driving approximately 65 MPH, the vehicle lost automotive power and stalled. The vehicle was towed to the local dealer who diagnosed that the crankshaft position sensor tone wheel had failed and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in NHTSA Campaign Number: 20V475000 (ENGINE AND ENGINE COOLING). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 127,000.

The Safety Recall has been on for 2 to 4 years NHTSA # 22V406000 Manufacturer Recall Number Z48 I've got many E mails about repairing the safety recall and No Service available I knew the fuel pressure pump is available please respond it worries me a lot to I may get in an accident

The contact owns a 2016 Ram 1500. The contact received notifications of NHTSA Campaign Numbers: 22V406000 (FUEL SYSTEM, DIESEL) and 23V411000 (ENGINE AND ENGINE COOLING); however, the parts to do the recall repairs were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue. The manufacturer was not made aware of the issue. The contact stated that while driving 5MPH, the vehicle started to stall, then jerked back and forth before eventually shutting off. The fuel control sensor warning light was illuminated. The vehicle was towed to the dealer where it was diagnosed with high-pressure fuel pump failure. The vehicle was in the process of being repaired; however, the dealer informed the contact that the parts were on backorder. The failure mileage was approximately 168,000. Parts distribution disconnect.

The last few weeks I’ve noticed my truck hasn’t been right. With some online investigation I realized the misfire code I been getting is related to a cam and lifter issue. Based on the forms I’ve viewed. The ram 1500 with the 5.7 engine has a known issue that the cams and lifters wear down after a very short period of time. I’ve seen cases of 60k miles up to 120k miles. This is a crucial part of the vehicle and there’s no reason this should only last for a short period of time. Especially with all these people who claim had to spend thousands of dollars on repairs or sometimes new engines entirely. I have older vehicles from the 2000’s with more miles than never have had issues like this. This is either a bad part that was produced or bad material of some sort. I’m hoping I’m not the only one to complain about this and we can try to resolve this issue.