2016 Ford Explorer Powertrain & Transmission Problems

Transmission was rebuilt by Asheville Ford three years ago we’d only put 40,000 miles on it and now it needs a new transmission. We did bring it to another Ford and they had to reseal the casing saying the original sealant wasn’t done right

The transmission shifts with a harsh jerk for no apparent reason and is an intermittent not constant problem. Also when stopped at an intersection refuses to engage to power the vehicle forward for a short time 5+ second time period.

The contact owns a 2016 Ford Explorer. The contact stated while driving 35 MPH, the vehicle shuddered abnormally with the check engine warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed and determined that the transfer case had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 135,401.

The contact owns a 2016 Ford Explorer. The contact stated that the vehicle experienced rough idles while his wife was driving the vehicle. The vehicle was taken to the dealer, where it was diagnosed that the torque converter had failed and needed to be replaced. The vehicle was not repaired. The vehicle was then taken to an independent mechanic, where it was confirmed that the torque converter needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 92,000.

I experienced two failures associated with other model years. The first was the right side A-pillar trim. It pulled free on the highway. I noticed it fly off and was able to recover the majority of it. It smashed on impact and there is a large piece missing. The remaining piece is available for inspection upon request. The A-pillar exterior trim flew off on a one-lane section of divided highway, there would have been no place for anyone to go if it flew back and there was a car behind me. This problem is a known issue I found out about on this (NHTSA) website. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? No, it flew off on the highway and has not been reported yet. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No warning at all that this was going to break loose. I also have an issue with the PTU. I was driving home from the airport and at a a stoplight, I noticed a ticking noise when I stopped at the exit of the parking lot. I noticed it again closer to home, after a fifty mile drive. When I stopped on the off ramp from the highway, I noticed smoke coming from under/behind my explorer. It smelled like antifreeze, but when I arrived home, and checked under the vehicle, I found black residue on the PTU and what looked like leaks from the axle seals that were not there for the last five months I've owned the vehicle. The vehicle smoked heavily when I stopped on the exit ramp, and when I went to accelerate into the traffic round-about, the vehicle lagged before moving, with an audible clunk and a lurch when it finally moved. Any reasonably hard acceleration produces a noise and will usually lag before moving. It may make a ticking noise when at idle cold, but is more pronounced the hotter the drivetrain gets. I had an OBD II scan done with no codes produced.

The contact owns a 2016 Ford Explorer. The contact stated that while attempting to reverse, the accelerator pedal was depressed; however, the vehicle hesitated while responding. The contact stated that after several attempts to depress the accelerator pedal, the vehicle responded as intended. The contact stated that a dealer was not contacted. The vehicle was not taken to be diagnosed or repaired. The manufacturer was notified of the failure but offered no assistance. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The contact related the failure to NHTSA Campaign Number: 20V692000 (POWER TRAIN); however, the VIN was not included in the recall. The approximate failure mileage was 168,000.

I have already filed a complaint about the transmission issues of my vehicle a few months ago. Ford will not take credit and help me so we had to keep driving it. Hard shifting, slipping, losing reverse, losing power and jerking into gear. Now not only has it nearly killed us twice when we went to pull into traffic, it has jerked into gear and locked up throwing the car into a guardrail and causing an accident while my fiancée was driving it. I reported it was unsafe and no one did anything, now I have a wreck vehicle, fighting with insurance about the safety of it and it’s sitting at a body shop. We are all afraid to drive it. It nearly killed my family and no one cared to help us. Plus we have no vehicle to drive now. Thank you FORD for nearly killing my family and making us feel unimportant in every way possible. Plus NHTSA did nothing when I filed my first complaint!

The second time my water pump has gone out in this vehicle. Causing over heating of the car and unrepairable wiring. Ford needs to get it right for us 2016 Ford Explorer owners. They [XXX] when it came to this vehicle. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2016 Ford Explorer. The contact stated that while driving at an undisclosed speed, the contact heard a loud sound coming from the engine compartment. There was no warning light illuminated. The vehicle was towed to the dealer, where it was diagnosed that the lower transmission and bolts had failed and needed to be replaced. The vehicle was repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for further assistance. The failure mileage was approximately 57,770.

Ptu burnt out less than 53k miles. Molding on passenger side broke off while driving 60mph struck another vehicle causing to other vehicle to leave road. Thank God no one was injured. This thing could have killed a motorcycle driver. Checked online and there are thousands of reports of same molding breaking off while driving.ford tn# does not recognize and disconnects call.

The contact owns a 2016 Ford Explorer. The contact stated that while driving at various speeds, the vehicle vibrated, and there was an abnormal knocking sound coming from the transmission. In addition, the vehicle drove roughly while the transmission was downshifting, and the vehicle failed to accelerate as needed. No warning lights were illuminated. The vehicle was taken to the dealer, where it was diagnosed with torque converter failure. The contact was informed that the torque converter needed to be replaced, or the transmission could be replaced. The vehicle remained at the dealer unrepaired. The manufacturer was made aware of the failure and referred contact to the NHSTA Hotline for assistance. Upon further investigation, the contact related the failure to the Technical Service Bulletin: 20B27. The failure mileage was approximately 100,000.

The contact owns a 2016 Ford Explorer. The contact stated while driving 10 MPH, the message to service the vehicle was displayed. The contact pulled over and turned off the vehicle, and waited for several minutes before restarting the vehicle and the message was no longer displayed. The contact stated that while depressing accelerator pedal, the vehicle failed to respond as needed. A dealer was contacted. The vehicle was taken to an independent mechanic where it was inspected to see if there were any leaks coming from the transmission. The contact called the Bob Johnson Auto Group to schedule an appointment for a diagnostic test. The vehicle was not repaired. The manufacturer was notified of the failure and opened a case. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The approximate failure mileage was 108,000.

The contact owns a 2016 Ford Explorer. The contact’s spouse stated that while driving at an undisclosed speed, the vehicle lost motive power. There was no warning light illuminated. The vehicle was not able to be restarted. The vehicle was towed to an independent mechanic where it was diagnosed that the link shaft bracket had failed and needed to be replaced. The vehicle was not repaired. The dealer was contacted. The vehicle was not repaired. The manufacturer was made aware of the failure and confirmed that the VIN was not included in NHTSA Campaign Number: 20V692000 (Power Train). The manufacturer referred the contact to the NHSTA Hotline for assistance. The approximate failure mileage was 157,627.

My vehicles wrench sign would turn on do a little jerk then I would lose power to my car. Showed malfunction to power train. Took it to mechanic said there was a Crack in the valve gasket and they fixed that and changed spark plugs. A month later car did the same thing. Has done it a total for 4 times very scary when on a high way and it does it and I have to pull over with traffic coming. Took it to another mechanic and he couldn't figure it out either because there are no codes but said he seem something similar and I needed to change all my coils. So I did that. Thousands of dollars later and no one can still figure out the problem. I don't know if it's some safety issue with the engine or transmission. But 3 certified mechanics can not figure out why my car continues to lose power.

Transfer case replacement. Open recall on 2016 4x2 ford explorera for faulty transfer case but not recalled on 4x4 models. This is BS as the transfer case used for both models are the exact same. Should be covered under already open recall for transfer case.

Transmission slips in and out of gear while driving causing loss of power. Many complaints online about this same issue from others.

The contact owns a 2016 Ford Explorer. The contact stated that the vehicle hesitated to shift into reverse properly, the vehicle would reverse a few feet and suddenly stall or stop from reversing when reversing out of a parking lot while a crunching sound could be heard from underneath the vehicle. No warning lights were illuminated. The vehicle was driven to an independent mechanic where the vehicle was diagnosed that the PTU needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 120,000.

The contact owns a 2016 Ford Explorer. The contact stated that the vehicle was experiencing significantly rough idling while in drive(D) or while in reverse(R). Additionally, the contact stated that while accelerating from a complete stop, the vehicle jolted and hesitated to respond. The contact also stated that the vehicle shuddered while driving at various speeds. There was no warning light illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed and determined that the failure was related to TSB Number: 20-2271. The dealer was notified of the failure. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that the TSB was superseded and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 102,000.

While driving vehicle down the road, steering locked up. Vehicle was taken to the dealer and diagnosed as a bad rack and pinion. This vehicle has 84,000 miles and should not already have issues with the rack and pinion. This incident, could have put my family and many other people's lives/vehicles at risk.

The torque converter failed in my explorer while driving, making it act like it was in neutral. Luckily I was on a small road with little traffic, and able to pull over to a side street before my car was complete undrivable. If this happened on the highway or while turning, it probably would have cause a major issue or accident. NO warning lights on my dash and NO problem codes reported on OBD scanner tool. Ford has put out their own CSP for this issue a while ago and when I asked about it they told me it was expired. How can something they know is an issue expire? Dealership repair confirmed it was the torque converter and has to rebuild the transmission. I even found a service bulletin ford release about this problem, so they know about it.