2020 Mercedes-Benz GLE-Class Engine Problems

Cooling system failure due to cracked coolant line beneath intake manifold at 57,000 miles. Part # 264-200-42-01. Sudden coolant loss can cause engine overheating and potential engine stall while driving, posing safety risks. The original part was plastic and has been superseded by manufacturer to metal, suggesting design inadequacy. This was confirmed by Mercedes Benz dealership and also by MB USA. There have been multiple reports by other owners online, indicating this has been a common problem on a 2020 GLE 350. There was also an article in Jan 2022 stating that Mercedes had sent a letter to 800,000 owners informing them of a defect, but no there was no recall due to part shortage. https://www.insurancejournal.com/news/international/2022/01/05/648140.htm Yes, dealership has diagnosed it and confirmed this is the problem. There was a warning lamp/message stating low coolant level, which prompted me to take the vehicle to the dealership. Car has been serviced regularly at the Mercedes dealership. Strong risk of overheating.

Cylinder head is defective and needs replacing. It is at the dealer for service at the tune of $7700. The car will not accelerate and sounds like it is in the wrong gear. Upon searching the Internet it seems like there are tons as in 1000’s of 2020, 2021 and 2023 Mercedes GLE 350s all having the same problem. There should be a recall as most cars are seeing this problem at 20,000 to 30,000 miles and at times when it is replaced, it turns around and happens again. Starting misfiring in October and continued to get worse.

The contact owns a 2020 Mercedes-Benz GLE350. The contact stated that while driving at various speeds, the vehicle failed to accelerate as intended while the accelerator pedal was depressed. The check engine warning light was illuminated. In addition, the contact stated that while the vehicle was stopped, the vehicle was idling low. The vehicle was taken to a local dealer, where it was diagnosed with a misfire in cylinder #4. The vehicle was not repaired. Upon further investigation, the contact related the failure to a NHTSA recall; however, the VIN was not included. The manufacturer was made aware of the failure. The failure mileage was approximately 100,000.

I am writing to express serious concern regarding a potentially dangerous mechanical issue with my Mercedes GLE 350. The vehicle has experienced a complete cylinder head failure, requiring an estimated $7,000 repair. Both an independent service center and an authorized Mercedes service center have confirmed this diagnosis. During the inspection process, Mercedes conducted two diagnostic tests—one costing $250 and a second costing $700—before determining that the cylinder head must be replaced. I was informed by the Mercedes service advisor that the company is aware this issue has affected other GLE 350 vehicles; however, no recall has been issued to date. This failure presents a significant safety risk. The vehicle suddenly loses power without warning, and acceleration becomes severely limited, often not exceeding 20–40 mph even when pressing the accelerator fully. The check engine light illuminates at the time of power loss, leaving the driver unable to maintain safe highway speeds or merge with traffic—posing a serious hazard to both the driver and others on the road. Given that this appears to be a known issue, I am requesting immediate review and investigation by Mercedes-Benz. A recall or formal service campaign should be considered to address this potentially dangerous defect and to ensure the safety of all affected drivers. Thank you for your prompt attention to this matter.

Engine Cylinder Head Failure on CPO Mercedes-Benz GLE 350 Vehicle Information: •Make: Mercedes-Benz •Model: GLE 350 •Year: 2020 •Mileage at time of issue: 90,000 Summary of Complaint: The vehicle experienced a premature cylinder head failure, resulting in significant engine damage and repair costs. There were no prior warning lights or diagnostic codes indicating a problem before the failure occurred. The malfunction caused sudden performance issues, including rough idling, misfiring, and loss of power. Details of the Incident: While operating the vehicle under normal driving conditions, the engine began to run roughly and lost power unexpectedly. Diagnostic testing revealed that the cylinder head had failed, which appears to be a mechanical or manufacturing defect rather than wear and tear. The repair estimate from the dealership was approximately $8,900, which is disproportionately high for a vehicle of this age and mileage. Safety Concerns: This type of failure could lead to sudden engine shutdown or loss of power while driving, posing a safety risk to occupants and other drivers on the road. Manufacturer Case Reference: This issue has also been reported to Mercedes-Benz under case number 18281587. Additional Information: After research, it appears that other Mercedes-Benz GLE owners have reported similar issues related to engine component failures, suggesting this may be a broader quality or manufacturing issue that warrants investigation. Requested Action: Requesting that NHTSA investigate potential defects in the engine or cylinder head assembly for the 2020 Mercedes-Benz GLE 350 and determine whether a recall or service bulletin is appropriate.

Check engine light came on September 2025 and the initial diagnosis was for mixture formation (cylinder 3) is irregular. Issue with the GLE 350 years 2020 to 2022 (from what I saw online) is the engine has an issue with a faulty cylinder head. This issue while driving causes the car to shake. This faulty cylinder has been confirmed by the Mercedes Benz service shop.

The contact owns a 2020 Mercedes-Benz GLE350. The contact stated that while driving at low speeds, the vehicle entered LIMP Mode but continued to operate with reduced motive power. The contact was able to pull over to the shoulder of the roadway, where the failure persisted. The check engine warning light was illuminated. The vehicle was towed to an independent mechanic, who diagnosed the vehicle with engine control unit failure causing the engine to run lean, resulting in misfires in cylinders #1 and #2 and damage to the engine. The contact was informed that the engine had failed a pressure test and needed to be replaced. The contact was advised to take the vehicle to the dealer for assistance. The vehicle was towed to the dealer, who confirmed the diagnosis and determined that the failure could be resolved with a top end engine replacement of the cylinder head, valves, valve springs, rocker arms, camshaft, spark plugs, and valve cover. The vehicle was not repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 71,000.

My 2020 Mercedes-Benz GLE 350 experienced a complete engine seizure at approximately 60,000 miles without any warning signs. The vehicle shut down and would not restart. The engine is completely inoperable. I am aware of recalls involving engine stalling and fuel system issues in this model, and I believe this may be related to a broader defect. Mercedes-Benz has not offered support as of this writing.

I purchased my 2020 Mercedes GLE 350 new with only 12 miles on it. I also purchased an extended warranty which gave me 100,012 miles. On a Friday evening while being driven, the engine light came on. I took the truck immediately to the dealership on Monday morning. Prior to that the engine would roar loud upon starting on some occasions then calm down. When I mentioned it to the service department on previous service visits they told me it was fine and they notice that, that particular model does that when it gets hot outside. The vehicle also quit on me in the middle of the road before starting back up in about 3 minutes but on a separate visit. ALL my maintenance and service have ALL been done at the Mercedes service department so I'm confused how this happened. So, the dealership needed an extra day to diagnose so after 2 days I was hit with the news that is was a cylinder head...$9,963. I had 108,152 (out of extended warranty) miles on my truck. I notice this is a common issue with this particular year and model GLE350. I also see that Mercedes has a recall on other models just not this one. A recall is needed immediately. I pray this complaint will help others that will experience this same issue in the near future because there's no help for me now.

The vehicle recently experienced a cylinder head failure, confirmed by a diagnotic code P0302 (Misfire in cylinder 2), resulting in rough idling, reduced power, and potential safety risks during opreration. This issue appears to be a known defect in the M264 engine, as evidenced by similar complains from owners of GLE 350, GLC 300, and other models on forums like [XXX] and [XXX] . The failure occurred just beyond the standard 4-year/50,000-mile warranty, and Mercedes-Benz USA denied my request for a goodwill repair despite acknowledging similar issues in related models under extended warranties. Repair costs are estimated $8,000 to $13,500. I believe this defect warrants investigation due to its prevalence and potential to cause sudden power loss, which could lead to hazardous driving conditions. I urge NHTSA to investigate the M264 engine in the 2020 GLE 350 for a possible recall to protect owners and ensure safety. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Hi! I just received word that my 2020 GLE350 will need a replacement cylinder head. I went to the dealership due to having a check engine light on (light came on this morning and I promptly brought to the dealership). It is an $8,000 repair. Upon doing a quick websearch for replacement cylinder heads for 2020 GLE350s, I am finding a lot of people in web groups reporting that they are having the exact same issues for the same model (2020-2022) right after the 50,000k mileage mark (out of warranty). I have always done my maintenance directly with the dealership. Links to the chat forums with similar issues - can pull up more if needed. [XXX] Let me know if you need additional information - thank you! INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Bought a 2020 Gle 350 used with 55000 miles on it. Within 3 weeks the check engine light comes on and the car goes into limp mode. Cannot drive it. Took it to Mercedes of Wilmington. They said it was a misfire on 4. They replaced all spark plugs and the coil to cylinder 4. Another month later the same thing happens. Took it back to Mercedes. Stated the car needs a new cylinder head at the cost of 12000$. This seems to be a common problem on these vehicles. A recall is needed immediately

At 48,000 miles the cylinder head needed replaced. This was done under warranty. At 73,000 miles the engine started making a horrible noise and power was lost and acceleration very choppy. Had it towed to the dealer. Dealer diagnosed the issue as a Rod bearing failure and requires the engine to be fully replaced. This occured while driving, fortunately I had just gotten off the highway, otherwise the vehicle would have lost acceleration and speed and would have created and unsafe situation. The engine light never came on, neither before or after the noise and loss of acceleration.

Coolant pipe under intake manifold made of plastic leaking, could have caused engine overheating and failure in traffic conditions. New style pipe supplied by manufacturer is now made of steel, dealer had in stock indicating a repetitive problem.

Turbo oil separator blocked, causing internal pressure pushing oil out of the rear main crankshaft seal. Since the oil level is monitored electrically (no dipstick), the engine can run out of oil, resulting in catastrophic failure while driving, causing a dangerous condition or accident

Cylinder misfire at low mileage with very costly repair.. Vehicle needs cylinder head.

My vehicle has developed problems related to the cylinder head, leading to persistent misfires, rough idling, and an illuminated check engine light. Upon diagnosis at an authorized Mercedes-Benz service center, it was determined that the cylinder head requires replacement

As many other GLE 350 owners reported on various forums, same thing happened to me. My car suddenly started shaking and some cylinders misfiring. My car is just 2020 and barely got 60,000 miles on it. Initial report shows that two cylinders misfires with no reason. It's failing the emission and car will not pass emission test anymore. Mercedes says it's out of warranty and asking 15k to replace cylinder head.

Campaign No. 2022030003, April 2022 My vehicle is experiencing the exact same issues, but the VIN was not tagged as one of the affected.

There is a leaking valve seat in the cylinder head 3. This causes the cylinder to lose compression, the car to lose power, and the vehicle fails to move from a full stop.