Dodge · Caliber · 2008
0
Recalls
377
Complaints
-
Not Rated
The 2008 Dodge Caliber has no recalls and 377 owner-reported complaints on file with NHTSA. Most reported issue: suspension (51 reports).
Source: NHTSA Public Records · Updated Apr 22, 2026
This page combines three types of NHTSA data: recall campaigns (official manufacturer or government actions), owner complaints (unverified consumer reports), and crash test ratings (where available). A vehicle with many complaints is not necessarily less reliable — complaint volume correlates with sales volume and vehicle age. Recalls indicate identified defects, not overall quality. To compare this model year with others, use the year navigation in the sidebar or return to the model overview page.
My vehicle has created a rotten subframe that holds my engine
My car shuts down while driving These cars recalled July10 2008 Mine was made April18 2008 but has the same issue It could cost lives
I’ve only had the car since Aug. Im the second owner, it drove just fine. Then I got an oil change. Then the car began to rev down hill and struggled to make it uphill. Then my exhaust became excessively loud. Then the wheel became loose ,and started pulling ALOT. I was on my way to get an alignment this morning and the whole front end began to buckle not even a minute down the road. I tmade it in back the driveway before the front end collapsed completely
Rear subframe rusted right through control rods snapped rear end of car dropped down. Upon researching they know that this is bad and unsafe even gave a 10 year extended warranty for front and rear subframe so how long will and how many complaints before this is an actual recall. I see here in your complaints that there is a large number of complaints on this issue. How are they getting away with this and nothing being done. I will have photos also police had said if this happened while it was on interstate would have crashed and could have been fatal. The tire would have ripped right off. So not only was my safety but the safety of the others being jeopardized cause everyone just keeps looking away at this issue. I would love to know how many of these subframes have had to be replaced I bet if you do research there is not one of them out there that either should be replaced have been replaced or will need to be replaced. Stop allowing these car companies to use sub standard parts. I am sure this will fall to the wayside along with the other 100 complaints. I will try my hardest to make sure everyone knows this is a problem that the car company is fully aware of and nobody has done anything about and keep researching on how many more this has happened to and try to get everyone to file a complaint. There was NO WARNING SIGN just broke loose passenger side of car was practically on the ground the broken control arm is what held everything up. Please can we really check into this if there is a recall at least people will know the problem exist.
Rear crossmember/ subframe rusted thru and broke. Replaced front several years ago. Car has always been garaged.
The entire underneath of my car is rusted out. I was driving to work one day when someone pulled out in front of me and I had to hit the brakes. That resulted in the subframe and front drivers axel to break as I’m driving! The sunroof leaks when it rains and half the time the electricity doesn’t work on the sunroof button. My doors have completely stopped auto locking and my hazards will randomly start flashing without pushing the button. Steering is absolutely terrible, it feels like you’re skidding on ice or hydroplaning the entire drive.
Subframe rusted front and rear Was driving tire axel/rod broke entire underneath rusted rotted
I was informed at inspection that the main front cross member has a huge hole in the center of it and is rusting out badly. At 162,356 miles this car will not pass safety inspection. This car is not safe for me or my family. No warning lamps or messages. I was told that one bad bump could do us in. We were told to contact the dealership and found out about the extended warranty that had already passed during the previous owners time. This should have been a recall, but what else can you expect from dodge.
The contact owns a 2008 Dodge Caliber. The contact stated while taking the vehicle into a local state inspection, he was notified that the vehicle did not pass inspection due to the K-frame of the undercarriage was fractured due to corrosion and rust. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 159,000.
2008 Dodge Caliber with approx. 135,000 miles on it. Rotted subframe and rusted crossbar. Vehicle started swerving as if driving on ice (in the summertime!). Took it to a reputable mechanic and he wouldn't even put it on a lift. He said it was too much of a risk. I understand this is common on this vehicle, it's dangerous and should be recalled! NO more Dodge vehicles for me, ever!
2008 DODGE CALIBER SUB FRAME/K-FRAME FRONT END CROSSMEMBER COMPLETELY RUSTED THRU CAUSING THE DRIVER SIDE LOWER CONTROL ARM TO RIP FREE FROM FRAME (SEPERATING PART OF FRAME, WITH LOWER CONTROL ARM) FROM REST OF FRAME. THIS LEFT DRIVER WITH NO CONTROL OF AFFECTED WHEEL WHICH TURNING IT 90 DEGREES OUT FROM NORMAL OPERATING POSITION. LEFT OPERATOR WITH NO ABILITY TO STEER WHILE DRIVING ON MAIN PRIMARY (35 MPH SPEED LIMIT) TWO LANE ROAD. CAR SLID TO HALT IN MIDDLE OF ROAD. CAR NEEDED TO BE TOWED. DODGE/CHRYSLER APPARENTLY KNEW OF THIS PROBLEM AND NEVER NOTIFIED OWNER. PLEASE SEE ATTACHED NOTICE. FRONT AND REAR CROSSMEMBER CORROSION (X69 WARRANTY EXTENSION) - 2008-2012 DODGE CALIBER & JEEP COMPASS/PATRIOT OEMDTC JULY 17, 2017 15 COMMENTS NHTSA ID NUMBER: 10140027 MANUFACTURER COMMUNICATION NUMBER: 23-007-17 REV. B SUMMARY FRONT AND REAR CROSSMEMBER CORROSION (X69 WARRANTY EXTENSION) THE DRIVER OF THIS CAR COULD HAVE BEEN KILLED OR SERIOUSLY HURT. IT IS UNFATHOMABLE THAT DODGE CHRYSLER WAS ALLOWED TO GET AWAY WITH NOT NOTIFYING POTENTIAL CRASH VICTIMS
TOOK VEHICLE IN FOR MAINTENANCE, TECHNICIAN TOLD US THE FRONT CROSSMEMBER IS RUSTED THROUGHOUT AND NEEDS REPLACEMENT. TECHNICIAN ADVISED IT'S A SAFETY ISSUE AND THIS MODEL WAS GIVEN EXTENDED WARRANTY UNDER X69 NOTICE, HOWEVER WARRANTY MAY HAVE ALREADY EXPIRED. I CONTACTED CHRYSLER REPRESENTATIVE AND THEY ADVISED THE VEHICLE WAS PART OF THE X69 NOTICE BUT WAS BEYOND THE EXTENDED WARRANTY THAT EXPIRED IN JUNE 2018. I AM THE SECOND OWNER OF VEHICLE BAND NEVER RECEIVED NOTICE OF THE ISSUE FROM CHRYSLER/DODGE. THE CROSSMEMBER RUST ISSUE APPEARS TO BE A COMMON PROBLEM WITH THIS MODEL. I AM REQUESTING AN INVESTIGATION AND RECALL FOR THIS PART.
THE FRONT CALIPERS WILL NOT ENGAGE WHEN BRAKE PEDAL IS PRESSED. THE BRAKE PEDAL SINKS TO THE FLOOR AND HAS NO STOPPING POWER. THE MASTER CYLINDER WAS REPLACED AND CALIPERS ARE NEW REPLACEMENTS. AFTER REPLACING THESE PARTS IT NOW SMELL OF BURNT BRAKE FLUID BUT THERE IS NO LEAK AND THE PROBLEM SEEMS TO WORSEN. THE FIRST TIME I WAS DOING 45-50 ON A COUNTY RD WHEN A ANOTHER CAR PULLED OUT 20 FEET AWAY AND I WAS TRYING TO SLOW DOWN WHEN I LOST THE FRONT BRAKES AS PISHED IN ON THE PUSHED IN ON THE BRAKES THE PEDAL SANK AND THEY DIDN'T ENGAGE. I THEN BOUGHT THE NEW CALIPERS AND IT WAS FINE FOR ABOUT A MONTH. THE SECOND TIME I WAS STUCK IN TRAFFIC ON A BUSY CITY STREET WHEN THE ABS BRAKES FAILED RESULTING IN ME RUNNING A RED LIGHT AND ALMOST GETTING HIT. IT HAS CORRODED AND TOOK HUNKS OFF ALUMINUM FROM MY FRONT DRIVER RIM. I HAVE NOT BEEN ABLE TO FIGURE OUT WHAT THE PROBLEM AND KEEP REPLACING PARTS FOR IT TO TEAR UP NEW ONES
I HAVE HAD MY 2008 DODGE CALIBER SINCE 2009. SINCE THEN I HAVE REPLACED BOTH TIE RODS 4 TIMES. I JUST HAD THEM DONE AGAIN ABOUT 1 1/2 YEARS AGO AND THEY ARE BROKEN AGAIN. I HAVE CHANGED THE BALL JOINTS AS WELL.. THIS IS RIDICULOUS AND SHOULD HAVE BEEN RECALLED I READ A LOT OF FORUMS AND EVERYBODY COMPLAINS ABOUT THE SAME THING.
MY 2008 DODGE CALIBER CROSS-MEMBER BROKEN IN THE MIDST OF ME DRIVING
RECENTLY PURCHASED A 2008 DODGE CALIBER(OHIO). ON INITIAL DRIVE RETURNING WITH VEHICLE I NOTICED A VIBRATION COMING THROUGH STEERING WHEEL. UPON INSPECTION, WAS INFORMED THE TIE ROD ENDS AND CONTROL ARMS BOTH COULD USE REPLACEMENT, BUT COULD HAVE BEEN CAUSED BY THE MORE IMPORTANT BAD FRONT AND REAR CROSSMEMBERS AS WELL AS FRONT AND REAR CRASH BARS, BOTH HAVE SEVERE RUST DEVELOPMENT WITH METAL DETERIORATION WHICH COULD IMPOSE A SAFETY CONCERN DOWN THE ROAD. WAS ADVISE TO LOOK INTO REPLACEMENT. REACHED OUT TO ONE OF THE LOCAL DEALERSHIPS AND WAS INFORMED IT WAS A BULLETIN, HAD AN EXTENDED WARRANTY, BUT AM OUTSIDE OF 10 YEAR PERIOD. RUST FROM CROSSMEMBER IS NOW IN PROCESS OF TRANSFERRING TO ACTUAL FRAME AND COMING THROUGH AS HOLES IN ROCKERS NOW AS WELL. DEALERSHIP OFFERING NO HELP AFTER STATING THE ENHANCED SAFETY CONCERN. HARD TO BELIEVE AN 08 CAN DETERIORATE SO FAST. YOU WOULD THINK WITH THE COMPLAINTS AND T.S.B. AS WELL AS SAFETY CONCERNS, SEEING STILL ORIGINAL PARTS THAT HAVE BEEN WARRANTIED TO REPLACE BUT HAVE NOT ON THIS VIN, GETS NO HELP AT ALL. *TR
MAKING NOISE GOING AROUND BEND 06052020. *TR
WHILE DRIVING MY CAR SPEED LOWERED AND THE TRANS TEMP LIGHT AND ESP LIGHT AND TRACTION CONTROL AND ETB MODULE LIGHT CAME CAR WON'T GO OVER 40 AND REMAINS IN LIMP MODE EVEN AFTER TAKING IT TO THE SHOP
WHILE MY WIFE WAS DRIVING, THE FRONT SUBFRAME CROSSMEMBER RUSTED THROUGH, CAUSING HER TO LOSE CONTROL OF THE CAR AND SHE COULD NOT SAFELY OPERATE IT WITHOUT REPAIR. I MANAGED TO GET IT TO A FIRESTONE FOR THEM TO LOOK AT AND THEY REFERRED ME TO A DEALER AND TOLD ME NOT TO DRIVE IT ANYMORE BECAUSE IT IS UNSAFE. THIS IS A PROBLEM THAT DODGE KNEW ABOUT, BUT FAILED TO NOTIFY ME ABOUT. I ONLY FOUND OUT ABOUT THE PROBLEM FROM THE DEALERSHIP, WHO TOLD ME THAT THE EXTENDED WARRANTY THAT COVERS THIS PROBLEM HAD EXPIRED IN 2018 AND THAT I WOULD BE RESPONSIBLE FOR THE COST OF ANY REPAIRS. I OWNED THE CAR DURING THAT TIME AND I DID NOT KNOW OF THIS PROBLEM, SO I COULD NOT ACT ON GETTING IT REPAIRED. THIS NEVER SHOULD HAVE BEEN AN EXTENDED WARRANTY, THIS SHOULD HAVE BEEN A RECALL BECAUSE OF THE POTENTIAL TO KILL PEOPLE WHEN THE SUBFRAME RUSTS OUT. MY WIFE WAS DRIVING IN A PARKING LOT AT THE TIME AT A RELATIVELY LOW SPEED, BUT HAD THIS HAPPENED ON A HIGHWAY IT COULD HAVE KILLED HER AND MY SON, AS WELL AS OTHERS ON THE ROAD. NUMBER: 23-007-17 REV. B GROUP: BODY DATE: MARCH 10, 2017 *TR
LUCKILY, I WAS ON A CITY STREET. THE VEHICLE LOST POWER AND SLOWED SIGNIFICANTLY, ALMOST STOPPING COMPLETELY AND BEGAN TO REBOOT AS IF IT WERE JUST BEING STARTED. I AM COMPLAINING BECAUSE I DO NOT FEEL IT TO BE SAFE FOR CONSUMERS ON ANY ROAD. I HAVE A 3 YEAR OLD SON AND I WOULD VERY MUCH LIKE DODGE TO FIX THIS PROBLEM BEFORE MY, OR ANYONE ELSE'S FAMILY, GETS WHIPLASH FROM A REAR COLLISION. I'M REACHING OUT TO NHTSA BECAUSE, I LACK THE TOOLS AND KNOWLEDGE TO FIX IT MYSELF, AND DON'T FIND IT FAIR THAT I PAY FOR A MISTAKE THAT DODGE MADE IN MAKING THE CAR. *TR
Showing 1–20 of 25 complaints
The 2008 Dodge Caliber has 0 recalls recorded by NHTSA.
NHTSA has received 377 owner-reported complaints for the 2008 Dodge Caliber.
NHTSA has not published a safety rating for the 2008 Dodge Caliber.
The most commonly reported complaint categories for the 2008 Dodge Caliber are suspension (51 reports), structure (44 reports), suspension,structure (20 reports).
NHTSA does not currently list any recalls on record for the 2008 Dodge Caliber. To verify the status of your specific vehicle, check nhtsa.gov/recalls with your VIN.
Look up recalls and complaints for any year, make, and model.
This page summarizes publicly available data from the National Highway Traffic Safety Administration (NHTSA). Complaint counts reflect reports submitted to NHTSA by vehicle owners and do not by themselves prove defect severity or vehicle safety. Safety ratings may not be available for all vehicle-years. This site is not affiliated with NHTSA or any vehicle manufacturer. For official information, visit the official NHTSA page for this vehicle.