2014 Jeep Cherokee Engine Problems

When I made an appointment at an authorized dealer and took it in they said I must wait for parts. They put me on a waiting list. During the waiting period my car started to get a check engine light and over heating warnings which the recall clearly states it’s been recalled from over heating. I contacted the dealer who said they didn’t have a loaner for me and they will contact me when the parts come in. All of a sudden the check engine light went off and the car was ok. Finally the parts came on and we took it right away to be serviced. A week after picking it up it started doing the same thing. I had emails going back and forth with service who claims it wasn’t due to the recall. During this I had a salesman call me to ask me to trade it in and when I said no he said, “Good luck with service.” Sarcastically. Finally they told me that they were emailing Jeep awaiting a response. But before this when they thought I would trade it in they were extremely happy. When I decided not to everything changed. My husband who didn’t trust them asked me to have it towed out of the dealer so I did. The car was drivable and no warning lights. Then a day later it starts giving warnings again. The car is now sitting in my garage. If you start it up and drive it the check engine light is on and the thermometer shows the temp going all the way up. I have re-opened my case that Jeep closed on me thinking the car was fixed. It has not been. The car still shows warning engine lights and overheating. It has not been fixed and the recall still stands unrepaired.

The contact owns a 2014 Jeep Cherokee. The contact stated while driving at an undisclosed speed, the engine overheated with the check engine warning light illuminated. The vehicle was able to be restarted but the failure persisted. The vehicle was towed to the dealer; however, the vehicle was not diagnosed, but it was stated by the dealer that the engine was repaired. The vehicle was repaired but the failure persisted. The contact stated that while her husband was driving at an undisclosed speed, the vehicle lost motive power. The vehicle was towed to an independent mechanic where it was diagnosed as a failure with the engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The dealer was contacted and notified of the failure. The manufacturer was made aware of the failure and a case was opened. The failure mileage was approximately 69,000. The VIN was not available.

While driving the vehicle will shift into neutral while saying it’s in drive. Then alert driver via display center on dashboard to “shift to P then desired gear”. The engine will completely shut off. Put into park, crank the engine, shift into drive then it will drive again.

The contact owns a 2014 Jeep Cherokee. The contact received notification of Emissions Recall U90 Catalyst Efficiency; however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.

The contact owns a 2014 Jeep Cherokee. The contact stated while driving on the highway at 35 MPH, the vehicle lost automotive power. The contact attempted to depress the accelerator pedal; however, the vehicle failed to accelerate. The contact pulled over to the side of the roadway to restart the vehicle. The vehicle was restarted, and the battery warning light was illuminated. The contact was able to continue driving. The local dealer was not contacted; however, the vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 220,000.

The contact owns a 2014 Jeep Cherokee. The contact stated that while driving 20 MPH exiting his driveway, the vehicle lost motive power. The contact was able to restart the vehicle and park the vehicle back in his driveway. The contact stated that when he turned the vehicle off, the vehicle did restart but would not remain running. The vehicle was taken to the dealer. The vehicle was diagnosed with a failed battery and a failed alternator. The contact was informed that the battery and the alternator needed to be replaced. The vehicle was repaired but the failure reoccurred. The dealer informed the contact that the electrical wiring harness was the cause of the failure. The contact was informed that the electrical wiring harness needed to be replaced. The contact stated that he purchased the parts for the electrical wiring harness replacement. The contact stated that the dealer then informed him that the electrical wiring harness was not the cause of the failure. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 150,000.

Check engine light came on, so I took it to my mechanic. Cylinder 1 is bad. The vehicle has 75000 miles and the engine needs to be replaced or at minimum cylinder one has to be repaired. Very expensive repair. I have done regular maintenance and still have an engine problem. I thought the engine would be good for at least 300000.

On March 7th 2023, I was driving my Jeep Cherokee on NY 96A in 55 mpa traffic, saw the check engine light turn on briefly, the engine seized at this speed, started chugging, and nearly had a traffic accident given the abrupt engine failure. In addition, while I was able to get to the side of the road, the car was stuck protruding off from the shoulder into the lane, the engine would not start to move the car, and it was a very unsafe situation given poor visibility at dusk. At 91,000 miles, it seems very strange to have experienced engine failure that ultimately resulted in a $6,785 repair bill at Maguire Jeep/Chrysler dealer in Ithaca, NY (VVA assembly needed to be replaced, broken valve spring in cylinder 4, roller spun and wedged in camshaft causing lobe damage, VVAA collapsed causing loose rocker and damaging head, valve and camshaft. Cylinder head needed to be rebuilt). This vehicle has had other serious problems in the past prior to this incident including a malfunctioning parking brake in 2020 that resulted in my 6 year old son and I stranded, unable to drive while we baked in the 90+ degree heat, a very costly broken 4wd module replacement 2021, and multiple breakdowns due to starter issues/needing starter to be rebuilt (2022 2x).

For the last 12-months I have been dealing with the vehicle stalling after filling it up. It first started a year ago and was sporadic but for the last 6-months it has been happening every time I fill up. This is a very dangerous situation to be driving down the road to have the vehicle suddenly stall out. The last time this happened was on Saturday, 2/11/23 and I spent the day fighting a stalling vehicle. Since 2020 the check engine light sporadically comes on. Supposedly there is a small evap leak. After looking into this earlier today I discovered this is a well known issue with all Jeep vehicles. Seeing how this seems to be a manufacturer issue the consumer should not have to keep paying out to fix what was not done right to begin with. Please look into both of these concerns.

Recently, after evertime I fill up with gas, my jeep stalls out and dies. I don't lose accessories or anything, I lose engine power. My battery like comes on and my dash says "battery voltage low" "put car into park and then desired gear" it takes a few tries to get it started again and it will buck like it wants to stall out or it dies again completely while I'm driving!

Similar to NTSB 11504810, when I fill up with gas, my jeep stalls out and dies. I don't lose accessories or anything, I lose engine power. My battery like comes on and my dash says "battery voltage low" "put car into park and then desired gear" it takes a few tries to get it started again and it will buck like it wants to stall out or it dies again completely while I'm driving. Also there are times it is rough changing gears (jerky).

Vehicle stalls/doesn’t start when gas tank is full. This has happened while driving.

It appears there is a problem with the engine oil cooler part that jeep need to fix so customers do not need to worry about oil leaks due to poor manufacturing of plastic parts Oil cooler fix is not cheap and why they put plastic parts near an engine that gets hot.

My car is a 2014 jeep cherokee TRAILHAWK the I bought a few mint ago at a keep dealer and after I bought the car 1000 miles later the car broke down due to a problem with the transmission, I took it back to the dealer and they didn’t wanted to fix it at first … after arguing with them for a couple of hours they resided to fix it and only made me pay for the part … after they supposedly fix it the car started giving me more problems and the dealer and the dealer didn’t wanted to fix it anymore

After filling up the gas tank the engine stalls at stop light. I must quickly place car in park and restart the engine. This happens multiple times as I drive home. Then as I start driving again the engine seems to be hesitant and feels like it is "bucking" me. After the first time this happened it seemed to go away after fuel level in tank went down. When I filled the tank again the problem reappeared. This has happened twice to me. This is really a life threatening hazard.

Car stalls out after fueling

It is well known on Jeep Cherokees from 2014 forward use plastic oil filter housings instead of metal. Plastic part in this heated area causes failure and leakage of oil into exhaust manifold. This problem is so prevalent that all Jeep dealers and other repair shops know that Chrysler Jeep Dodge can’t even keep up the demand for the part replacement, AND still they do not make it out of metal. This problem is well known and costs $ 1000 - 1300 to repair. Why is NHTSA not forcing Jeep to recall all the Jeeps with problems and replace the oil filter housing with a metal product !! This is abuse to loyal Jeep owners, with a known problem which all participants are aware of, but no one is holding Jeep accountable !

When the fuel tank is filled, to the first click off of the pump. The vehicle will stall, sputter, and is hard to accurate. The dealer has all ready replaced the fuel tank, evap line, and a puger valve, but still has the same problems. I have almost getting rear ended when it stalls a couple of times. Still has been going on for 2+ year. Vehicle drives fine after 30ish miles after filling it up.

OME Oil Filter Housing is made of plastic and it cracked, causing the Jeep to leak oil. This is a common issue with the 3.2L and 3.6L jeep motors. So common that the original part has been discontinued and replaced with one made of metal. That fact that Jeep has discontinued the original part and replaced it with a better one should be grounds for a recall and be covered my Jeep. Instead I have to pay $200 for the part and because of the labor required to replace the part, my total bill is almost $1000.

The oil filter adapter has cracked due to it being a plastic housing. Cold weather speeds up the process. The oil filter adapter also has a small torque tolerance for the cap that will also break the housing. This is available for inspection upon request. The safety concern is that the oil leaks out on top of the motor then down the sides and onto the exhaust below causing emission tests to fail. My dealer mentioned this is common but nothing official. The component has not been inspected by police or insurance. The dash indicators don’t come on till enough oil leaks out to display low oil level.