2016 Mazda Mazda3

The contact owns a 2016 Mazda Mazda3. The contact stated that while driving and while starting the vehicle, the instrument cluster was inoperable. The contact also stated that the instrument cluster screen was peeling, and critical information for the vehicle was not displayed. Additionally, the infotainment system became intermittently inoperable due to the failure. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The contact expressed concerns that the inoperable instrument cluster created a hazardous and unsafe condition due to the complete loss of instrument panel functionality. The approximate failure mileage was 142,000.

I am writing to formally report a serious safety issue with my 2016 Mazda 3 manual transmission, which experienced a sudden and complete clutch failure at less 60,000 miles — without any warning lights or diagnostic alerts. I am deeply concerned that: •There was no dashboard warning, even as the clutch system failed •The gear indicator was inaccurate in prior days, which may have been an early sign of failure •There was no protection mechanism to prevent complete drivetrain failure during normal use.

The "Infotainment System" is activating itself and cycling through various options when I slow down or stop. It calls random numbers and changes settings on the system. It is distracting and dangerous. This is a known "ghost touch" problem for this model of vehicle, but the Mazda dealer I contacted in Knoxville, TN said it would cost nearly $300 to repair the problem (by replacing the entire system).

Mazda supposedly repaired/replaced the backup camera issue under the recall. However, within one day it was doing the same thing again...the screen dims or flickers off when backing up the car. I told Mazda about that and they said I need a new screen, which would not be covered under the recall. This is a safety hazard that they should be required to address.

The contact owns a 2016 Mazda Mazda3. The contact stated that while the vehicle was parked, the driver’s side seat belt became inoperable. The contact stated that the seat belt latch failed to function properly. The vehicle was taken to the dealer but was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 60,000.

The contact owns a 2016 Mazda Mazda3. The contact stated while the vehicle was parked, the parking brake became firm and failed to engage as needed, causing the rear passenger’s side brake pads to not respond as needed after the vehicle was repaired under NHTSA Campaign Number: 17V393000 (PARKING BRAKE). The contact stated that the recall repair failed to fix the vehicle. There was no warning light illuminated. The contact checked the temperature of the brakes and noticed that the brakes were hotter than normal. A dealer was contacted. The vehicle was towed to the dealer where it was diagnosed that the parking brake actuator was rusted on the inside. The vehicle was not repaired. The manufacturer was notified of the failure and opened a case. The failure mileage was 188,900.

When I checked for recall information 2 recalls were listed under my car's vin #: Recall #1: 3219D with Closed status. Recall #2: 6023G is listed as Active. But, when I tried to schedule a repair for the active recall, the manufacturing website ONLY listed the "closed" recall (3219D) was listed as available for repair, which is bizarre. Please see the attached screenshot of the website. Thanks.

I am now experiencing the problems outlined in [XXX] approximately 18 months after the extended warranty period has ended for me. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

It’s been over a year since recall number 23v-487 was issued Need to get it taken care of

Fuel Tank has corrosion that allows vapors to enter the passenger compartment.

Rear view camera intermittently cuts out. Recall was issued 07/14/23 yet there is no fix yet??? Mazda Recall #: 6023G NHTSA Recall #: 23V-487

The recall related to the rear backup camera has not been addressed and it is more than a year later. I just got off the phone with a Mazda representative and they still do not have a solution nor know when one might be available. I would like to sell my car but with a defective backup camera and view screen, I will have trouble doing so and/or won't get as much for the vehicle as I should. I have a 5 year old and I don't feel safe driving this vehicle, as the rearview camera turns off suddenly at times when I am reversing the vehicle. I would like to submit a compliant for negligence on Mazda's part and urge you to do something to make them fix this defect. Thanks.

I WAS NOTIFIED OF A RECALL CONCERNING THE CAMERA IN MY CAR IN SEPTEMBER OF 2023. IT WILL SOON BE SEPTEMBER 2024 AND I HAVE NOT BEEN NOTIFIED THAT THE PARTS NEEDED ARE CURRENTLY AVAILABLE.ORIGINAL RECALLNOTICE STATED THAT REPLACEMENT PARTS WERE NOT AVAILABLE AT THAT TIME. HOW CAN THIS BE CALLED AN IMPORTANT SAFETY RECALL WHEN A YEAR HAS GONE BY MY CAMERA NOT ONLY FLICKERS, BUT MOST OF THE TIME IT DOESN'T COME ON AT ALL! PLEASE ADVISE WHAT I SHOULD DO NEXT.

The “spidering” on the infotainment screen is spidering making it hard to see when in reverse.

The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The Mazda Connect touch screen in the center display does not accept touch commands properly or will often operate by itself (ghost touch). When it does this, even though I will have navigation on, it will interrupt the service to jump screens, causing me to lose guidance and force me to pull-over to try to deal with the issue. I have had to swerve in my lane trying to correct the issue until I have the opportunity to pull-over, and it has been dangerous to me and the folks on the road with me when this happens.

Reverse camera stops working at random for several hours at a time. Mazda has issued a recall for this issue but has yet to offer repair

The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while shifted into reverse, the digital display screen flickered before going black and failed to display a proper rearview image. Upon further inspection, the contact noticed that when the A/C was activated, the rearview image was flickering quickly. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The manufacturer was made aware of the failure. The failure mileage was unavailable. VIN tool confirms parts not available.

The cup holder on the car seat is damaged, as it broke from the car seat at the time of the incident. The hook in which buckles the car seat to the car is stuck and no longer pulls out nor in, No longer able to tie the car seat into the car correctly. My child is put at risk due to the buckle not being able to tighten nor more. Yes the insurance first stated they would replace it.

The 2014 Mazda3 I own has a known "Mazda Connect Touch Screen Concern" in August 2019 in which the Mazda Connect touch screen does not accept touch commands in part of the screen. I called Mazda and they said there are not any recalls for this but they did acknowledge this was an issue.